RONETIX Adds NAND FLASH Programming to PEEDI JTAG Emulator and Programmer

Ronetix today announced the availability of the new firmware of its high speed, low cost JTAG Emulator and Flash Programmer for ARM7, ARM9 and XScale based micro controllers. The new firmware adds support of direct programming NAND FLASH memory connected to an ARM or an XSCALE MCU. This unique feature enables the easy use of NAND FLASH memory as a boot device. PEEDI supports 8 and 16 bit NAND chips up to 8Gbit. There is also a bad block management, which handles the bad blocks during programming and enables PEEDI to forcibly mark blocks as bad or healthy.

RONETIX PEEDI JTAG Emulator and Programmer with NAND FLASH Programming

PEEDI can be used in standalone mode to program more that 800 flash devices as well as AT91SAM7, LPC2000, MAC7100, STR7, TMS470 and Atmel DataFlash families.

PEEDI supports native GNU gdb and provides a very high real download speed – up to 1Mbytes/s.

Among the advantages of PEEDI are:

  • Multi core support – up to 4 cores
  • Built-in support for gdb (remote target via Ethernet)
  • Very high real download speed – up to 1Mbytes/s
  • 5 kHz – 33MHz JTAG clock using 35cm standard cable
  • Target Voltage 1.2V – 5V
  • Built-in telnet command line interface
  • Built-in very fast Flash programmer that supports over 800 Flash devices
  • Can be used as a standalone Flash Programmer, up to 15 images stored on MMC/SD card controlled by front panel interface
  • Small robust aluminum case
  • DCC over TCP support

About Ronetix
Ronetix supplies complete software toolkits, flash programmers intelligent debug probes and development boards for the ARM7, ARM9 and XScale technology implementations. The Company headquarters are in Vienna, Austria. For sales information on RONETIX’s products contact